BROSINSKY - Flüssigmetall - Techniklogo

Fluid level - and flow measurements

flüssigmetallführenden in pipes


 

Application

With the inductive level measurement, the metal concentrations are determined in the manifold. This type of measurement is therefore especially when Low pressure mold castings sense, because here is to be held by a casting process of Liquid metal levelbelow the mold. With the same probe can also be measured in the flow tubes.

 

Construction

The probe is fixed as a three-coil system above the pipe, the middle coil of the transmitter (S) and the two Outdoor coil the receiver (E).

When filling the tube changes the induced voltage receiver - the ride height is measured in the probe. The difference between the two voltages is proportional to the flow receiver.